#$&*
course PHY 201
6/1/2012 9:00(It would not allow me to submit it on the actual Pear Pendulum form. This is my sixth time attempting to submit this lab; this is my first time on a submit work form)
Samantha Rogers
PHY 201
THe Pearl Pendulum
http://vhcc2.vhcc.edu/dsmith/forms/ph1_pearl_pendulum.htm
The bead is referred to below as the 'pearl'.
When the pearl is released it swings back to the bracket, bounces off the swings back again, repeatedly striking the bracket. The magnet can be used to clamp the thread so the length of the pendulum remains constant.
If you have just a plain bracket then you simply tilt the bracket in order to achieve a constant rhythm, as described below.
You should set the system up and allow the pearl to bounce off the bracket a few times. The bracket should be stationary; the pendulum is simply pulled back and released to bounce against the bracket.
Note whether the pearl strikes the bracket more and more frequently or less and less frequently with each bounce. If the pearl does not bounce off the bracket several times after being released, it might be because the copper wire below the pearl is getting in the way. If necessary you can clip some of the excess wire (being careful to leave enough to keep the bead from falling through).
If the bracket is tilted back a bit, as shown in the next figure below, the pearl will naturally rest against the bracket. Tilt the bracket back a little bit and, keeping the bracket stationary, release the pendulum.
Listen to the rhythm of the sounds made by the ball striking the bracket.
• Do the sounds get closer together or further apart, or does the rhythm remain steady? I.e., does the rhythm get faster or slower, or does it remain constant?
• Repeat a few times if necessary until you are sure of your answer.
Insert your answer into the space below, and give a good description of what you heard.
Your response (start in the next line):
When the bracket is tilted back, the sounds of the pearl striking the bracket gets closer and closer together. This means that the rhythm gets faster. The pearl was striking the bracket at an increasing rate.
#$&*
If the bracket is tilted forward a bit, as shown in the figure below, the pearl will naturally hang away from the bracket. Tilt the bracket forward a little bit (not as much as shown in the figure, but enough that the pearl definitely hangs away from the bracket). Keep the bracket stationary and release the pendulum. Note whether the pearl strikes the bracket more and more frequently or less and less frequently with each bounce.
Again listen to the rhythm of the sounds made by the ball striking the bracket.
• Do the sounds get closer together or further apart, or does the rhythm remain steady? I.e., does the rhythm get faster or slower, or does it remain constant?
• Repeat a few times if necessary until you are sure of your answer.
Insert your answer into the box below, and give a good description of what you heard.
Your response (start in the next line):
WHen the bracket is tilted forward, the sound of the pearl striking the brackets seems to occur further and further apart. This means that the rhythm is getting slower and slower. The pearl was striking the bracket at a decreasing rate.
#$&*
If the bracket is placed on a perfectly level surface, the pearl will hang straight down, just barely touching the bracket. However most surfaces on which you might place the bracket aren't perfectly level. Place the bracket on a smooth surface and if necessary tilt it a bit by placing a shim (for a shim you could for example use a thin coin, though on most surfaces you wouldn't need anything this thick; for a thinner shim you could use a tightly folded piece of paper) beneath one end or the other, adjusting the position and/or the thickness of the shim until the hanging pearl just barely touches the bracket. Pull the pearl back then release it.
If the rhythm of the pearl bouncing off the bracket speeds up or slows down, adjust the level of the bracket, either tilting it a bit forward or a bit backward, until the rhythm becomes steady.
Describe the process you used to make the rhythm steady, and describe just how steady the rhythm was, and how many times the pendulum hit the bracket..
Your response (start in the next line):
When the bracket was placed on a level surface. The rhythm remained steady. The pendulum hit the bracket a total of six times at this steady rate.
#$&*
On a reasonably level surface, place one domino under each of the top left and right corners of your closed textbook, with the front cover upward. Place the bracket pendulum on the middle of the book, with the base of the bracket parallel to one of the sides of the book. Release the pendulum and observe whether the sounds get further apart or closer together. Note the orientation of the bracket and whether the sounds get further apart or closer together.
Now rotate the base of the bracket 45 degrees counterclockwise and repeat, being sure to note the orientation of the bracket and the progression of the sounds.
Rotate another 45 degrees and repeat.
Continue until you have rotated the bracket back to its original position.
Report your results in such a way that another student could read them and duplicate your experiment exactly. Try to report neither more nor less information than necessary to accomplish this goal. Use a new line to report the results of each new rotation.
Your response (start in the next line):
After placing two dominos under my book, one in the top right and one in the top left, I put the bracket in the middle of the book. I made sure that the bracket was parallel to the sides. I made it so that the front of the bracket was facing toward the top of the book, or facing the incline. After releasing the pendulum the sounds got closer and closer together. The I rotated the pendulum 45 degrees counterclockwise and repeated the process. With ever 45 degrees of rotation the sounds of the pendulum hitting the bracket continuously got further and further apart. Once rotated a full 180 degrees, the pendulum was facing the opposite of the incline. The sounds on the pendulum was significantly further apart then the original position. When rotating every 45 back towards the pendulums original position the sounds of the pendulum began to get closer and closer together.
#$&*
Describe how you would orient the bracket to obtain the most regular 'beat' of the pendulum.
Your response (start in the next line):
The bracket obtained the most regular 'beat' of the pendulum when it was placed at a 90 degree angle to the side of the book.
#$&*
Orient the bracket in this position and start the TIMER program. Adjust the pendulum to the maximum length at which it will still bounce regularly.
Practice the following procedure for a few minutes:
Pull the pendulum back, ready to release it, and place your finger on the button of your mouse. Have the mouse cursor over the Click to Time Event button. Concentrate on releasing the pendulum at the same instant you click the mouse, and release both. Do this until you are sure you are consistently releasing the pendulum and clicking the mouse at the same time.
Now you will repeat the same procedure, but you will time both the instant of release and the instant at which the pendulum 'hits' the bracket the second time. The order of events will be:
• click and release the pendulum simultaneously
• the pendulum will strike the bracket but you won't click
• the pendulum will strike the bracket a second time and you will click at the same instant
We don't attempt to time the first 'hit', which occurs too soon after release for most people to time it accurately.
Practice until you can release the pendulum with one mouse click, then click again at the same instant as the second strike of the pendulum.
When you think you can conduct an accurate timing, initialize the timer and do it for real. Do a series of 8 trials, and record the 8 time intervals below, one interval to each line. You may round the time intervals to the nearest .001 second.
Starting in the 9th line, briefly describe what your numbers mean and how they were obtained.
Your response (start in the next line):
0.602
0.566
0.581
0.577
0.565
0.539
0.504
0.491
These eight number indicate the eight times that the pendulum hit the bracket. I obtained them by using the TIMER program. I clicked the timer button at each strike of the pendulum.
#$&*
Finally, you will repeat once more, but you will time every second 'hit' until the pendulum stops swinging. That is, you will release, time the second 'hit', then time the fourth, the sixth, etc..
Practice until you think you are timing the events accurately, then do four trials.
Report your time intervals for each trial on a separate line, with commas between the intervals. For example look at the format shown below:
.925, .887, .938, .911
.925, .879, .941
etc.
In the example just given, the second trial only observed 3 intervals, while the first observed 4. This is possible. Just report what happens in the space below. Then on a new line give a brief description of what your results mean and how they were obtained.
Your response (start in the next line):
0.634, 0.587, 0.603, 0.657
0.691, 0.644, 0.704
0.664, 0.639, 0.689, 0.712
0.689, 0.624, 0.699, 0.710
The above results represent the data collected form the four trials. For every trial the pendulum was timed at every second, fourth, and sometimes eighth, strikes of the pendulum.
#$&*
Now measure the length of the pendulum. (For the two-pearl system the length is measured from the bottom of the 'fixed' pearl (the one glued to the top of the bracket) to the middle of the 'swinging' pearl. For the system which uses a bolt and magnet at the top instead of the pearl, you would measure from the bottom of the bolt to the center of the pearl). Using a ruler marked in centimeters, you should be able to find this length to within the nearest millimeter.
What is the length of the pendulum?
Your response (start in the next line):
6.5 cm
#$&*
If you have timed these events accurately, you will see clearly that the time from release to the second 'hit' appears to be different than the time between the second 'hit' and the fourth 'hit'.
On the average,
• how much time elapses between release and the second 'hit' of the pendulum,
• how much time elapses between the second and fourth 'hit' and
• how much time elapses between the fourth and sixth 'hit'?
Report your results as three numbers separated by commas, e.g.,
.63, .97, .94
Your response (start in the next line):
0.6695, 0.6235, 0.674
#$&*
A full cycle of a free pendulum is from extreme point to equilibrium to opposite extreme point then back to equilibrium and finally back to the original extreme point (or almost to the original extreme point, since the pendulum is losing energy as it swings)..
The pearl pendulum is released from an 'extreme point' and strikes the bracket at its equilibrium point, so it doesn't get to the opposite extreme point.
It an interval consists of motion from extreme point to equilibrium, or from equilibrium to extreme point, how many intervals occur between release and the first 'hit'?
Your response (start in the next line):
One interval occurs from the release point (extreme point) to equilibrium. (1/4 of a full cycle)
#$&*
How many intervals, as the word was described above, occur between the first 'hit' and the second 'hit'? Explain how your description differs from that of the motion between release and the first 'hit'.
Your response (start in the next line):
Two intervals occur between the first hit an the second hit. The pendulum must travel from equilibrium and back to its extreme point and then from that extreme point back to equilibrium. This differs from that of the motion between release an the first 'hit' because the pendulum is starting at the extreme point and heading towards equilibrium so only one interval is needed.
#$&*
@&
From equilibrium back to equilibrium itself involves motion from extreme to equilibrium, and more.
*@
How many intervals occur between release and the second 'hit', and how does this differ from the motion between the second 'hit' and the fourth 'hit'?
Your response (start in the next line):
Two intervals, it is half the amount from the motion between the second hit and the fourth hit.
#$&*
@&
Between the release and second 'hit' the pendulum makes two trips from extreme to equilibrium, and that doesn't account for all its motion.
*@
How many intervals occur between the second 'hit' and the fourth 'hit', and how does this differ from a similar description of the motion between the fourth 'hit' and the sixth 'hit'?
Your response (start in the next line):
Four intervals. The same amount of time intervals occurs between the second and fourth hit compared to the fourth and sixth hit.
#$&*
Why would we expect that the time interval between release to 2d 'hit' should be shorter than the subsequent timed intervals (2d to 4th, 4th to 6th, etc.)?
Your response (start in the next line):
With every strike of the pendulum, it begins to lose momentum and decrease in speed. Therefore at the time interval between the release and the second hit is shorter then the subsequent timed intervals.
#$&*
Would we expect additional subsequent time intervals to increase, decrease or stay the same?
Your response (start in the next line):
We would expect additional subsequent time intervals to stay about the same because the rhythm was constant.
#$&*
What evidence does this experiment provide for or against the hypothesis that the length of a pendulum's swing depends only on its length, and is independent of how far it actually swings?
Your response (start in the next line):
The experiment proves that it is not just the length of the pendulum that dictates the swing. The extreme point at which it is released, the accuracy of the time measured, and the positioning of the bracket are all factors that affect the pendulum swing.
#$&*
Your instructor is trying to gauge the typical time spent by students on these experiments. Please answer the following question as accurately as you can, understanding that your answer will be used only for the stated purpose and has no bearing on your grades:
• Approximately how long did it take you to complete this experiment?
Your response (start in the next line):
1 hr 30 minutes
#$&*"
&#This lab submittion looks good. See my notes. Let me know if you have any questions.
Revision isn't requested, but if you do choose to submit revisions, clarifications or questions, please insert them into a copy of this document, and mark your insertions with &&&& (please mark each insertion at the beginning and at the end).
Be sure to include the entire document, including my notes. &#