initial timing experiment

phy 201

Your 'initial timing experiment' report has been received. Scroll down through the document to see any comments I might have inserted, and my final comment at the end.

** template form

Initial Timing Experiment


You may enter any message or comment you wish in the box below:

________________ **

** ________

In this experiment you will use the TIMER program, a hardcover book, a cylinder or some other object that will roll along the book in a relatively straight line, and a ruler or the equivalent (if you don't have one, note the RULERS link on the Assignments page).

Place the book on a flat level tabletop.  You will prop one end of the book up a little bit, so that when it is released the object will roll without your assistance, gradually speeding up, from the propped-up end to the lower end.  However don't prop the end up too much.  It should take at least two seconds for the ball to roll down the length of the book when it is released from rest.

Then reverse the direction of the book on the tabletop, rotating the book and its prop 180 degrees so that the ball will roll in exactly the opposite direction.  Repeat your measurements.

In the box below describe your setup, being as specific as possible about the book used (title, ISBN) and the object being used (e.g., a solid glass marble, a small can of tomato paste (full or empty?), a ball-point pen), and what you used to prop the object up (be as specific as possible).   Also describe how well the object rolled--did it roll smoothly, did it speed up and slow down, did it roll in a straight line or did its direction change somewhat?

Note:  Don't trust this form.  Compose your answer in Notepad or a word processor, saving it every few minutes, then copy and paste it into the box.  Power could surge, your computer could malfunction, in any of a number of ways the work you put into this form could be lost.  Compose it elsewhere and keep a copy.

________________ **

I used my physics book, (ISBN 0-13-060620-0) propped up with a stack of papers(3mm thick). The book is 11 inches long(28 cm) and 4 cm thick. I am using a dry erase marker to roll down the book. The marker rolled really smooth down the entire surface of the book. It started out very slow and gradually built up speed.

** ________

In the box below report your data.  State exactly what was measured, how it was measured, how accurately you believe it was measured and of course what the measurements were.  Try to organize your report so the reader can easily scan your data and see any patterns that might occur.

________________ **

The thickness of the book was 4 cm, the length of the book was 28 cm, the book was elevated 3 mm on one end. I believe the measurements are relatively accurate due to the fact that I was using a plastic ruler used for advertisement.

** ________

Using your data determine how fast the object was moving, on the average, as it rolled down the incline.  Estimate how accurately you believe you were able to determine the object's average speed, and give the best reasons you can for your estimate of the accuracy.

________________ **

On an average, the object was moving 12.44 cm per second. I beleive it was very accurate due to the fact I measured the time about 15-20 times and found the average, and I know the length of the book was accurate.

** ________

Devise and concuct an experiment to determine whether or not the object is speeding up as it rolls down the incline.  If you have set the experiment up as indicated, it should seem pretty obvious that the object is in fact speeding up.  But figure out a way to use actual measurements to support your belief.

Explain how you designed and conducted your experiment, give your data and explain how your data support your conclusions.

________________ **

I set a rigid scale in the middle of my book and measured the time it took to reach middle of the book. It took an average of 1.75 seconds to reach the scale. That means that the remaining half second of the entire roll is spent on the back half of the book. The results of this experiment are: It takes 78 percent of the total roll time to cover the first half of the book, leaving only 22 percent of the total time for the back half (bottom of ramp). The object is obviously speeding up.

Down the front half of the book, the object is going 8cm per second on average. Down the back half of the book, the object is going 28cm per second on average.

** ________

Your instructor is trying to gauge the typical time spent by students on these experiments.  Please answer the following question as accurately as you can, understanding that your answer will be used only for the stated purpose and has no bearing on your grades: 

________________ **

1 hour

** ________


You may add optional comments and/or questions in the box below.

________________ **

&#Your work looks good. Let me know if you have any questions. &#

initial timing experiment

phy 201

Your 'initial timing experiment' report has been received. Scroll down through the document to see any comments I might have inserted, and my final comment at the end.

** template form

Initial Timing Experiment


You may enter any message or comment you wish in the box below:

________________ **

** ________

In this experiment you will use the TIMER program, a hardcover book, a cylinder or some other object that will roll along the book in a relatively straight line, and a ruler or the equivalent (if you don't have one, note the RULERS link on the Assignments page).

Place the book on a flat level tabletop.  You will prop one end of the book up a little bit, so that when it is released the object will roll without your assistance, gradually speeding up, from the propped-up end to the lower end.  However don't prop the end up too much.  It should take at least two seconds for the ball to roll down the length of the book when it is released from rest.

Then reverse the direction of the book on the tabletop, rotating the book and its prop 180 degrees so that the ball will roll in exactly the opposite direction.  Repeat your measurements.

In the box below describe your setup, being as specific as possible about the book used (title, ISBN) and the object being used (e.g., a solid glass marble, a small can of tomato paste (full or empty?), a ball-point pen), and what you used to prop the object up (be as specific as possible).   Also describe how well the object rolled--did it roll smoothly, did it speed up and slow down, did it roll in a straight line or did its direction change somewhat?

Note:  Don't trust this form.  Compose your answer in Notepad or a word processor, saving it every few minutes, then copy and paste it into the box.  Power could surge, your computer could malfunction, in any of a number of ways the work you put into this form could be lost.  Compose it elsewhere and keep a copy.

________________ **

I used my physics book, (ISBN 0-13-060620-0) propped up with a stack of papers(3mm thick). The book is 11 inches long(28 cm) and 4 cm thick. I am using a dry erase marker to roll down the book. The marker rolled really smooth down the entire surface of the book. It started out very slow and gradually built up speed.

** ________

In the box below report your data.  State exactly what was measured, how it was measured, how accurately you believe it was measured and of course what the measurements were.  Try to organize your report so the reader can easily scan your data and see any patterns that might occur.

________________ **

The thickness of the book was 4 cm, the length of the book was 28 cm, the book was elevated 3 mm on one end. I believe the measurements are relatively accurate due to the fact that I was using a plastic ruler used for advertisement.

** ________

Using your data determine how fast the object was moving, on the average, as it rolled down the incline.  Estimate how accurately you believe you were able to determine the object's average speed, and give the best reasons you can for your estimate of the accuracy.

________________ **

On an average, the object was moving 12.44 cm per second. I beleive it was very accurate due to the fact I measured the time about 15-20 times and found the average, and I know the length of the book was accurate.

** ________

Devise and concuct an experiment to determine whether or not the object is speeding up as it rolls down the incline.  If you have set the experiment up as indicated, it should seem pretty obvious that the object is in fact speeding up.  But figure out a way to use actual measurements to support your belief.

Explain how you designed and conducted your experiment, give your data and explain how your data support your conclusions.

________________ **

I set a rigid scale in the middle of my book and measured the time it took to reach middle of the book. It took an average of 1.75 seconds to reach the scale. That means that the remaining half second of the entire roll is spent on the back half of the book. The results of this experiment are: It takes 78 percent of the total roll time to cover the first half of the book, leaving only 22 percent of the total time for the back half (bottom of ramp). The object is obviously speeding up.

Down the front half of the book, the object is going 8cm per second on average. Down the back half of the book, the object is going 28cm per second on average.

** ________

Your instructor is trying to gauge the typical time spent by students on these experiments.  Please answer the following question as accurately as you can, understanding that your answer will be used only for the stated purpose and has no bearing on your grades: 

________________ **

1 hour

** ________


You may add optional comments and/or questions in the box below.

________________ **

Your work here is well done and well expressed.