initial timing experiment

Your 'initial timing experiment' report has been received. Scroll down through the document to see any comments I might have inserted, and my final comment at the end.

** template form

Initial Timing Experiment


You may enter any message or comment you wish in the box below:

________________ **

** ________

In this experiment you will use the TIMER program, a hardcover book, a cylinder or some other object that will roll along the book in a relatively straight line, and a ruler or the equivalent (if you don't have one, note the RULERS link on the Assignments page).

Place the book on a flat level tabletop.  You will prop one end of the book up a little bit, so that when it is released the object will roll without your assistance, gradually speeding up, from the propped-up end to the lower end.  However don't prop the end up too much.  It should take at least two seconds for the ball to roll down the length of the book when it is released from rest.

Then reverse the direction of the book on the tabletop, rotating the book and its prop 180 degrees so that the ball will roll in exactly the opposite direction.  Repeat your measurements.

In the box below describe your setup, being as specific as possible about the book used (title, ISBN) and the object being used (e.g., a solid glass marble, a small can of tomato paste (full or empty?), a ball-point pen), and what you used to prop the object up (be as specific as possible).   Also describe how well the object rolled--did it roll smoothly, did it speed up and slow down, did it roll in a straight line or did its direction change somewhat?

Note:  Don't trust this form.  Compose your answer in Notepad or a word processor, saving it every few minutes, then copy and paste it into the box.  Power could surge, your computer could malfunction, in any of a number of ways the work you put into this form could be lost.  Compose it elsewhere and keep a copy.

________________ **

I used a 1/2 inch three ring binder, therefore it was already propped up at a slight angle. I also used a ball point pen, taking the cap off therefore there was nothing on the pen to stop it from rolling smoothly down the ramp.

** ________

In the box below report your data.  State exactly what was measured, how it was measured, how accurately you believe it was measured and of course what the measurements were.  Try to organize your report so the reader can easily scan your data and see any patterns that might occur.

________________ **

The notebook was measured with a ruler printed off of the assignments page of this course's website, and i believe it to be a very accurate measurement. The length of the ramp is 25 cm. The height of the ramp is 3.45 cm.

** ________

Using your data determine how fast the object was moving, on the average, as it rolled down the incline.  Estimate how accurately you believe you were able to determine the object's average speed, and give the best reasons you can for your estimate of the accuracy.

________________ **

The average speed I came up with for my incline was 29.8507 cm/s -- which i believe equals .298507 m/s; correct me if I'm wrong, because I'm not 100% sure if that was the right way to conver the cm to m.

29.9 cm = .299 m, so 29.9 cm/s = .299 m/s. Your conversion was fine.

I'm pretty sure about my accuracy, because i found the average time, which i in turn used with the distance of the ramp in order to find the speed.

** ________

Devise and concuct an experiment to determine whether or not the object is speeding up as it rolls down the incline.  If you have set the experiment up as indicated, it should seem pretty obvious that the object is in fact speeding up.  But figure out a way to use actual measurements to support your belief.

Explain how you designed and conducted your experiment, give your data and explain how your data support your conclusions.

________________ **

By putting different markers on the book, or in my case, notebook, that were evenly spaced apart, and then clicked the timer every time the object moved over one of thsoe timers, the data would show that the object was in fact speeding up because the time between each equally spaced interval would get shorter, instead of staying the same.

** ________

Your instructor is trying to gauge the typical time spent by students on these experiments.  Please answer the following question as accurately as you can, understanding that your answer will be used only for the stated purpose and has no bearing on your grades: 

________________ **

about 30 min

** ________


You may add optional comments and/or questions in the box below.

________________ **

&#

Very good responses. Let me know if you have questions. &#