#$&*
course Phy 122
1/22 1pm
Question: Suppose you measure the length of a pencil. You use both a triply-reduced ruler and the original ruler itself, and you make your measurements accurate to the smallest mark on each. You then multiply the reading on the triply-reduced ruler by the appropriate scale factor.
• Which result is likely to be closer to the actual length of the pencil?
your answer: vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv The triply-reduced ruler would be more accurate to measure the actual length of the pencil because the tic marks would be closer together allowing for a more accurate measurement.
#$&*
• What factors do you have to consider in order to answer this question and how do they weigh into your final answer?
your answer: vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv You have to consider what in the world a triply-reduced ruler is—which I took to be a ruler shrunk to one/third of the size of the original ruler. In addition, you have to understand what reducing an image would do.
#$&*
*********************************************
Question: Answer the same questions as before, except assume that the triply-reduced ruler has no optical distortion, and that you also know the scale factor accurate to 4 significant figures.
• Which result is likely to be closer to the actual length of the pencil?
your answer: vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
The triply-reduced ruler with no optical distortion and a scale factor accurate to 4 Sig Digs would be closer to the actual length of the pencil.
#$&*
• What factors do you have to consider in order to answer this question and how do they weigh into your final answer?
your answer: vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
You have to consider the accuracy of the original ruler compared to the accuracy of the smaller ruler. In addition, you must consider what would allow you to more accurately measure length.
#$&*
*********************************************
Question: Suppose you are to measure the length of a rubber band whose original length is around 10 cm, measuring once while the rubber band supports the weight of a small apple and again when it supports the weight of two small apples. You are asked to report as accurately as possible the difference in the two lengths, which is somewhere between 1 cm and 2 cm. You have available the singly-reduced copy and the triply-reduced copy, and your data from the optical distortion experiment.
• Which ruler will be likely to give you the more accurate difference in the lengths?
your answer: vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
I do not understand the question at all. Are the singly-reduced copy and triply-reduced copy copies of a ruler? If so, then I suppose the triply-reduced copy assuming no distortion would provide a more accurate measurement.
#$&*
• Explain what factors you considered and how they influence your final answer.
your answer: vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
I considered that while enlarging an image distorts the picture, reducing it shouldn’t. In addition, with a smaller image, the tic marks would be smaller allowing for a more accurate measurement.
#$&*
*********************************************
Question: Later in the course you will observe how the depth of water in a uniform cylinder changes as a function of time, when water flows from a hole near the bottom of the cylinder. Suppose these measurements are made by taping a triply-reduced ruler to the side of a transparent cylinder, and observing the depth of the water at regular 3-second intervals.
The resulting data would consist of a table of water depth vs. clock times, with clock times 0, 3, 6, 9, 12, ... seconds. As depth decreases the water flows from the hole more and more slowly, so the depth changes less and less quickly with respect to clock time.
Experimental uncertainties would occur due to the optical distortion of the copied rulers, due to the spacing between marks on the rulers, due to limitations on your ability to read the ruler (your eyes are only so good), due to timing errors, and due to other possible factors.
Suppose that depth changes vary from 5 cm to 2 cm over the first six 3-second intervals.
Assume also that the timing was very precise, so that there were no significant uncertainties due to timing.
• Based on what you have learned in experiments done through Assignment 1, without doing extensive mathematical analysis, estimate how much uncertainty would be expected in the observed depths, and briefly explain the basis for your estimates. Speculate also on how much uncertainty would result in first-difference calculations done with the depth vs. clock time data, and how much in second-difference calculations.
your answer: vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
Since the ruler is triply reduced and according to the statement above optical distortion, I would expect the uncertainty to be three times as much as the original ruler. First difference calculations would then be six times uncertain and second difference calculations would then be nine times uncertain.
#$&*
• How would these uncertainties affect a graph of first difference vs. midpoint clock time, and how would they affect a graph of second difference vs. midpoint clock time?
your answer: vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
The uncertainties would affect the graph of first difference vs. clock time by making the line graph more jagged. The second difference graph would be even more jagged than the first difference. Because the uncertainties are not only x2 and x3, but x6 and x9, the graphs will be more jagged than normal.
#$&*
• How reliably do you think the first-difference graph would predict the actual behavior of the first difference?
your answer: vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
I don’t think the first difference graph would be very reliable, however, it would be more reliable than the second-difference graph.
#$&*
• Answer the same for the second-difference graph.
your answer: vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
The second-difference graph is very unreliable.
#$&*
• What do you think the first difference tells you about the system? What about the second difference?
your answer: vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
The first difference tells you the change in position. The second difference tells you the change in velocity.
#$&*
*********************************************
Question: Suppose the actual second-difference behavior of the depth vs. clock time is in fact linear. How nearly do you think you could estimate the slope of that graph from data taken as indicated above (e.g., within 1% of the correct slope, within 10%, within 30%, or would no slope be apparent in the second-difference graph)?
your answer: vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
I think I could estimate within 10%.
#$&*
Again no extensive analysis is expected, but give a brief synopsis of how you considered various effects in arriving at your estimate.
your answer: vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv
If the graph is linear, slope can be predicted fairly well.
#$&*
*#&!
@& Very good. You have an excellent handle on the ideas of precision and accuracy.*@