#$&*
Phy 232
Your 'measuring atmospheric pressure' report has been received. Scroll down through the document to see any comments I might have inserted, and my final comment at the end.
** Measuring Atmospheric Pressure_labelMessages **
I submitted this already and was wondering if you had received it because it is not on my access page. I'll resubmit just in case.
** Measuring Atmospheric Pressure_labelMessages **
When you squeeze the bottle, the water moves up the vertical tube and the air in the end of the pressure tube is compressed a little bit further the further the water moves up and bottle is squeezed.
** **
I used the rulers that were reduced that looked to be about half the size of the real measurement of a centimeter to be able to measure more closely but be able to clearly read the marks still.
** **
The length of the air column is 53 (smaller than regular) cm. I obtained the result by measuring both ends and marking them, then finding the length with them.
** **
15 cm 53 73.1, 75.2 73.2, 75.5 73.1, 75.3 73.3, 75.6 73.2, 75.5 I obtained this information by using the directions to follow them out on the system I set up, and this information shows the amount of pressure applied to the bottle since the pressure of the two change in the same amount.
** **
25 cm 53 73.1, 77.0 73.2, 77.2 73.1, 77.1 73.1, 76.9 73.2, 77.3
** **
35 cm 53 73.0, 79.1 73.1, 79.3 73.1, 79.0 73.2, 79.2 73.2, 79.1
** **
** **
1 hour
&#Good work on this lab exercise. Let me know if you have questions. &#