course Phy 201 ????????{?????assignment #005
......!!!!!!!!...................................
15:24:30 `q001. Note that there are 9 questions in this assignment. If the acceleration of an object is uniform, then the following statements apply: 1. A graph of velocity vs. clock time forms a straight line, either level or increasing at a constant rate or decreasing at a constant rate. 2. The average velocity of the object over any time interval is equal to the average of its velocity at the beginning of the time interval (called its initial velocity) and its velocity at the end of the time interval (called its final velocity). 3. The velocity of the object changes at a constant rate (this third statement being obvious since the rate at which the velocity changes is the acceleration, which is assumed here to be constant). 4. The acceleration of the object at every instant is equal to the average acceleration of the object. Suppose that an object increases its velocity at a uniform rate, from an initial velocity of 5 m/s to a final velocity of 25 m/s during a time interval of 4 seconds. By how much does the velocity of the object change? What is the average acceleration of the object? What is the average velocity of the object?
......!!!!!!!!...................................
RESPONSE --> a) to get the change in velocity you subtract your two velocities so 25m/s- 5m/s = 20m/s b) average acceleration is average rate of change of velocity with respect to clock time so change of velocity / time = 20m/s/4s = 5m/s^2 c) average velocity is its average rate of change of position with respect to clock time so vAvg = (25m/s + 5m/s) /2 = 15m/s confidence assessment: 3
.................................................
......!!!!!!!!...................................
15:25:31 The velocity of the object changes from 5 meters/second to 25 meters/second so the change in velocity is 20 meters/second. The average acceleration is therefore (20 meters/second) / (4 seconds) = 5 m / s^2. The average velocity of the object is the average of its initial and final velocities, as asserted above, and is therefore equal to (5 meters/second + 25 meters/second) / 2 = 15 meters/second (note that two numbers are averaged by adding them and dividing by 2).
......!!!!!!!!...................................
RESPONSE --> I understand all of these problems so far no problems self critique assessment: 3
.................................................
......!!!!!!!!...................................
15:31:41 `q002. How far does the object of the preceding problem travel in the 4 seconds?
......!!!!!!!!...................................
RESPONSE --> the distance traveled = the acceleration * time so 5m/s^2 * 4 sec = 20m/s confidence assessment: 3
.................................................
......!!!!!!!!...................................
15:40:45 The displacement `ds of the object is the product vAve `dt of its average velocity and the time interval, so this object travels 15 m/s * 4 s = 60 meters during the 4-second time interval.
......!!!!!!!!...................................
RESPONSE --> I didnt realize that the distance traveled was considered displacement which does make sense. so instead of multiplying by the acceleration i should have multiplied by the average velocity . self critique assessment: 3
.................................................
......!!!!!!!!...................................
15:46:32 `q003. Explain in commonsense terms how we determine the acceleration and distance traveled if we know the initial velocity v0, and final velocity vf and the time interval `dt.
......!!!!!!!!...................................
RESPONSE --> the acceleration is determined by the average rate of change of velocity with respect to clock time so if you have the initial and final velocity you can subtract them and divide by the time to get the acceleration. you get the distance traveled by multiplying by the average velocity and the time interval so to get the average velocity you add your initial and final vel and divide by 2 then you take that number and multiply by the time it takes to travel and you get the distance traveled. confidence assessment: 3
.................................................
......!!!!!!!!...................................
15:47:07 In commonsense terms, we find the change in velocity since we know the initial and final velocities, and we know the time interval, so we can easily calculate the acceleration. Again since we know initial and final velocities we can easily calculate the average velocity, and since we know the time interval we can now determine the distance traveled.
......!!!!!!!!...................................
RESPONSE --> ok i said that in more words but it was the same thing. self critique assessment: 3
.................................................
......!!!!!!!!...................................
15:56:22 `q004. Symbolize the situation by first giving the expression for the acceleration in terms of v0, vf and `dt, then by giving the expression for vAve in terms of v0 and vf, and finally by giving the expression for the displacement in terms of v0, vf and `dt.
......!!!!!!!!...................................
RESPONSE --> the acceleration : aAve = vf-v0/'dt average velocityu: vAve= (vf + v0)/2 displacement: 'ds = (vf +v0)/2 * 'dt confidence assessment: 3
.................................................
......!!!!!!!!...................................
15:57:00 The acceleration is equal to the change in velocity divided by the time interval; since the change in velocity is vf - v0 we see that the acceleration is a = ( vf - v0 ) / `dt.
......!!!!!!!!...................................
RESPONSE --> ok i got that right understood self critique assessment: 3
.................................................
......!!!!!!!!...................................
15:57:29 `q005. The average velocity is the average of the initial and final velocities, which is expressed as (vf + v0) / 2.
......!!!!!!!!...................................
RESPONSE --> ok i got that one right too i understand it. confidence assessment: 3
.................................................
......!!!!!!!!...................................
15:58:08 When this average velocity is multiplied by `dt we get the displacement, which is `ds = (v0 + vf) / 2 * `dt.
......!!!!!!!!...................................
RESPONSE --> ok i got all of those questions right. i understand. self critique assessment: 3
.................................................
......!!!!!!!!...................................
16:07:27 `q006. This situation is identical to the previous, and the conditions implied by uniformly accelerated motion are repeated here for your review: If the acceleration of an object is uniform, then the following statements apply: 1. A graph of velocity vs. clock time forms a straight line, either level or increasing at a constant rate or decreasing at a constant rate. 2. The average velocity of the object over any time interval is equal to the average of its velocity at the beginning of the time interval (called its initial velocity) and its velocity at the end of the time interval (called its final velocity). 3. The velocity of the object changes at a constant rate (this third statement being obvious since the rate at which the velocity changes is the acceleration, which is assumed here to be constant). 4. The acceleration of the object at every instant is equal to the average acceleration of the object. Describe a graph of velocity vs. clock time, assuming that the initial velocity occurs at clock time t = 0. At what clock time is the final velocity then attained? What are the coordinates of the point on the graph corresponding to the initial velocity (hint: the t coordinate is 0, as specified here; what is the v coordinate at this clock time? i.e., what is the velocity when t = 0?). What are the coordinates of the point corresponding to the final velocity?
......!!!!!!!!...................................
RESPONSE --> the slope between two points represents the average rate of change of velocity with respect to clock time which is the average acceleration corresponding to this interval. if the time is 0 then the initial velocity is also 0 it has not moved yet. there is not enough information for me to determine the final velocity. the coordinates that i think are (0, 0) confidence assessment: 1
.................................................
......!!!!!!!!...................................
16:10:58 The initial velocity of 5 m/s occurs at t = 0 s so the corresponding graph point is (0 s, 5 m/s). The final velocity of 25 meters/second occurs after a time interval of `dt = 4 seconds; since the time interval began at t = 0 sec it ends at at t = 4 seconds and the corresponding graph point is ( 4 s, 25 m/s).
......!!!!!!!!...................................
RESPONSE --> Enter, as appropriate, an answer to the question, a critique of your answer in response to a given answer, your insights regarding the situation at this point, notes to yourself, or just an OK. Always critique your solutions by describing any insights you had or errors you makde, and by explaining how you can make use of the insight or how you now know how to avoid certain errors. Also pose for the instructor any question or questions that you have related to the problem or series of problems. I did not realize that i was suppose to use the information from the first problem to answer this question. had i known i could have just plugged in some numbers and got the answer. initial vel = 5m/s at t=0 would be (0s, 5 m/s) time ends at 4 sec so (4s, 25 m/s) self critique assessment: 3
.................................................
......!!!!!!!!...................................
16:13:20 `q007. Is the graph increasing, decreasing or level between the two points, and if increasing or decreasing is the increase or decrease at a constant, increasing or decreasing rate?
......!!!!!!!!...................................
RESPONSE --> the graph is increasing between the two points, it is increasing at a constant rate. confidence assessment: 2
.................................................
......!!!!!!!!...................................
16:13:46 Since the acceleration is uniform, the graph is a straight line. The graph therefore increases at a constant rate from the point (0, 5 m/s) to the point (4 s, 25 m/s).
......!!!!!!!!...................................
RESPONSE --> i got this question right no critique necessary. self critique assessment: 3
.................................................
......!!!!!!!!...................................
16:16:47 `q008. What is the slope of the graph between the two given points, and what is the meaning of this slope?
......!!!!!!!!...................................
RESPONSE --> the slope between two points represents the average rate of change of velocity with respect to clock time, which is the average acceleration corresponding to this interval the slope is rise / run. which is 20m/s / 4 s = 5 m/s^2 confidence assessment: 3
.................................................
......!!!!!!!!...................................
16:17:32 The rise of the graph is from 5 m/s to 25 m/s and is therefore 20 meters/second, which represents the change in the velocity of the object. The run of the graph is from 0 seconds to 4 seconds, and is therefore 4 seconds, which represents the time interval during which the velocity changes. The slope of the graph is rise / run = ( 20 m/s ) / (4 s) = 5 m/s^2, which represents the change `dv in the velocity divided by the change `dt in the clock time and therefore represents the acceleration of the object.
......!!!!!!!!...................................
RESPONSE --> i got this question right no critique necessary. self critique assessment: 3
.................................................
......!!!!!!!!...................................
16:31:17 `q009. The graph forms a trapezoid, starting from the point (0,0), rising to the point (0,5 m/s), then sloping upward to (4 s, 25 m/s), then descending to the point (4 s, 0) and returning to the origin (0,0). This trapezoid has two altitudes, 5 m/s on the left and 25 m/s on the right, and a base which represents a width of 4 seconds. What is the average altitude of the trapezoid and what does it represent, and what is the area of the trapezoid and what does it represent?
......!!!!!!!!...................................
RESPONSE --> the altitude represents the average value of the quantity represented by the vertical coordinate. so i think that i subtract the 25 and the 5 to get an altitude of 20m/s. then the area of the trapezoid is defined by a linear segment of a graph is equal to the area of the rectangle defined by the midpoint of that segment so the area of the rectangle represents the product of the average value of the vertical quantity and the chang in the value of the horizontal quantity. so it sould be 25 - 5 * 4 - 0 = 20 * 4 = 80m/s confidence assessment: 1
.................................................
......!!!!!!!!...................................
16:38:07 The two altitudes are 5 meters/second and 25 meters/second, and their average is 15 meters/second. This represents the average velocity of the object on the time interval. The area of the trapezoid is equal to the product of the average altitude and the base, which is 15 m/s * 4 s = 60 meters. This represents the product of the average velocity and the time interval, which is the displacement during the time interval.
......!!!!!!!!...................................
RESPONSE --> I messed up on this problem the average of the two altitudes is 25+5/2 which is 15 m/s which is the average velcoity. the area is the average altitude times the time. so 15m/s * 4s = 60 meters. this represents the displacement during the time interval. self critique assessment: 3
.................................................