course Phy 232 028. `Query 28*********************************************
.............................................
Given Solution: ** For current running in a circular loop: Each small increment `dL of the loop is a source I `dL. The vector from `dL to the center of the loop has magnitude r, where r is the radius of the loop, and is perpendicular to the loop so the contribution of increment * `dL to the field is k ' I `dL / r^2 sin(90 deg) = I `dL / r^2, where r is the radius of the loop. The field is either upward or downward by the right-hand rule, depending on whether the current runs counterclockwise or clockwise, respectively. The field has this direction regardless of where the increment is located. The sum of the fields from all the increments therefore has magnitude B = sum(k ' I `dL / r^2), where the summation occurs around the entire loop. I and r are constants so the sum is B = k ' I / r^2 sum(`dL). The sum of all the length increments around the loop is the circumference 2 pi r of the loop so we have B = 2 pi r k ' I / r^2 = 2 pi k ' I / r. ** &&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&& Self-critique (if necessary): I just stated the formula and didn’t explain any of it. I thought that was all that was needed.
.............................................
Given Solution: STUDENT RESPONSE: We do have evidence that electric currents produce magnetic fields. This is observed in engineering when laying current carrying wires next to each other. The current carrying wires produce magnetic fields that may affect other wires or possibly metal objects that are near them. This is evident in the video experiment. When Dave placed the metal ball near the coil of wires and turned the generator to produce current in the wires the ball moved toward the coil. This means that there was an attraction toward the coil which in this case was a magnetic field. INSTRUCTOR COMMENT: Good observations. A very specific observation that should be included is that a compass placed over a conducting strip or wire initially oriented in the North-South direction will be deflected toward the East-West direction. ** How is the direction of an electric current related to the direction of the magnetic field that results? ** GOOD STUDENT RESPONSE: The direction of the magnetic field relative to the direction of the electric current can be described using the right hand rule. This means simply using your right hand as a model you hold it so that your thumb is extended and your four fingers are flexed as if you were holding a cylinder. In this model, your thumb represents the direction of the electric current in the wire and the flexed fingers represent the direction of the magnetic field due to the current. In the case of the experiment the wire was in a coil so the magnetic field goes through the hole in the middle in one direction. ** Query problem 17.35 &&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&& Self-critique (if necessary): I think my answer is true it just wasn’t what this question was looking for.
.............................................
Given Solution: ** If a parallel-plate capacitor holds charge Q and the plates are separated by air, which has dielectric constant very close to 1, then the electric field between the plates is E = 4 pi k sigma = 4 pi k Q / A, obtained by applying Gauss' Law to each plate. The voltage between the plates is therefore V = E * d, where d is the separation. The capacitance is C = Q / V = Q / (4 pi k Q / A * d) = A / (4 pi k d). Solving this formula C = A / (4 pi k d) for A for the area we get A = 4 pi k d * C If capacitance is C = .20 F and the plates are separated by 2.2 mm = .0022 m we therefore have A = 4 pi k d * C = 4 pi * 9 * 10^9 N m^2 / C^2 * .20 C / V * .0022 m = 5 * 10^7 N m^2 / C^2 * C / ( J / C) * m = 5 * 10^7 N m^2 / (N m) * m = 5 * 10^7 m^2. ** &&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&& Self-critique (if necessary): I must have messed up with my units somewhere. I should have written them as you multiplied the problem. ------------------------------------------------ Self-critique Rating: 3 ********************************************* Question: `qquery univ 24.50 (25.36 10th edition). Parallel plates 16 cm square 4.7 mm apart connected to a 12 volt battery. What is the capacitance of this capacitor? YYYYYYYYYYYYYYYYYYYYYYYYYYYYYYYYYYYYYYYYYYY Your Solution: You would first find the electric field by taking 12/0.0047 = about 2550 V/m You would then take 4*pi*k*sigma=2250 and solve for sigma. This would give us 2.25*10^-8 C/m^2. We would next find the area by multiplying the sigma value by 0.0256 m^2 which gives us about 5.76 * 10^-10 C. Next we would take the 5.76*10-8/12 which is 4.7 * 10^-11 C / V. This would be the capacitance. We would then do 12 V / 2 * (5.76 * 10^-10 C) = 3.4 * 10^-9 V / m * C which is the energy. Confidence rating: 3
.............................................
Given Solution: ** Fundamental principles include the fact that the electric field is very neary constant between parallel plates, the voltage is equal to field * separation, electric field from a single plate is 2 pi k sigma, the work required to displace a charge is equal to charge * ave voltage, and capacitance is charge / voltage. Using these principles we reason out the problem as follows: If the 4.7 mm separation experiences a 12 V potential difference then the electric field is E = 12 V / (4.7 mm) = 12 V / (.0047 m) = 2550 V / m, approx. Since the electric field of a plane charge distribution with density sigma is 2 pi k sigma, and since the electric field is created by two plates with equal opposite charge density, the field of the capacitor is 4 pi k sigma. So we have 4 pi k sigma = 2250 V / m and sigma = 2250 V / m / (4 pi k) = 2250 V / m / (4 pi * 9 * 10^9 N m^2 / C^2) = 2.25 * 10^-8 C / m^2. The area of the plate is .0256 m^2 so the charge on a plate is .0256 m^2 * 2.25 * 10^-8 C / m^2 = 5.76 * 10^-10 C. The capacitance is C = Q / V = 5.67 * 10^-10 C / (12 V) = 4.7 * 10^-11 C / V = 4.7 * 10^-11 Farads. The energy stored in the capacitor is equal to the work required to move this charge from one plate to another, starting with an initially uncharged capacitor. The work to move a charge Q across an average potential difference Vave is Vave * Q. Since the voltage across the capacitor increases linearly with charge the average voltage is half the final voltage, so we have vAve = V / 2, with V = 12 V. So the energy is energy = vAve * Q = 12 V / 2 * (5.76 * 10^-10 C) = 3.4 * 10^-9 V / m * C. Since the unit V / m * C is the same as J / C * C = J, we see that the energy is 3.4 * 10^-9 J. Pulling the plates twice as far apart while maintaining the same voltage would cut the electric field in half (the voltage is the same but charge has to move twice as far). This would imply half the charge density, half the charge and therefore half the capacitance. Since we are moving only half the charge through the same average potential difference we use only 1/2 the energy. Note that the work to move charge `dq across the capacitor when the charge on the capacitor is `dq * V = `dq * (q / C), so to obtain the work required to charge the capacitor we integrate q / C with respect to q from q = 0 to q = Q, where Q is the final charge. The antiderivative is q^2 / ( 2 C ) so the definite integral is Q^2 / ( 2 C). This is the same result obtained using average voltage and charge, which yields V / 2 * Q = (Q / C) / 2 * Q = Q^2 / (2 C) Integration is necessary for cylindrical and spherical capacitors and other capacitors which are not in a parallel-plate configuration. ** &&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&& Self-critique (if necessary): I had to look down to stay on track, but I think I understood the majority of it. ------------------------------------------------ Self-critique Rating: 3 "